|
A note from our owner and engineer,
Curtis
Hanvey 
Grooming trailers of this size are rather rare and built
specifically on a custom basis. As always, Hanvey takes good care of the our clients and we encourage your personal input, which will ensure your complete comfort and satisfaction.
This gooseneck trailer requires a standard/long
bed pick-up truck to tow. If you have a short bed, we do not recommend this unit. This trailers width is 8' and a standard or long bed tow vehicle is required to
allow clearance for the forward corners of the trailer to clear the back of the
cab when turning tight turns.
This trailer is a custom design and
it is spec 'ed for a generator to be located in the forward compartment for easy installation and access to the generator. This means this trailer is ready for you to install
your own generator, but make sure the generator is picked to fit the size of the
compartment. If you select a larger generator, the compartment side
walls can be modified to accommodate the larger generator but that is a choice
reserved for you.
The "granny's attic" is 10' long and the width varies from 8' down
to about 6' on the front end. This mini room is 4.5 feet tall. This picture is a composite
picture showing the forward cabinet in center and a second cabinet to the right.
This area has its own rooftop A/C with heat strip.
The entrance to the room is the door located above the removable
ladder on the front wall of the grooming area (shown below).

As you can see in the picture, the grooming area has an entrance
door on the right side and the grooming area is concentrated on the left side.
There is another cabinet located to the bottom right across from the tub but it
can not be seen in the above picture. The picture below is that cabinet.

Notice that there is a counter area just behind and above this rear cabinet.
This counter runs completely across the rear of the trailer and is the top of
the equipment and water tank cabinet. This counter serves as the storage space
for misc. grooming items of your choice. In the picture below you can see the
right side of the counter area located adjacent to the tub.

The grooming area can accommodate the shown tub and table.
The shown tub has been removed. The new buyer will have a
new epoxy coated, gray Edemco tub unless they decide to opt in this premium
grade stainless steel tub for an additional $2,528. The shown tub is
manufactured by Forever Stainless Steel to our custom specifications.
The table acts as an elevator lift to raise the big dogs up and into the tub
when the clear Lexan side is removed. Never lift a big dog again.

When you open the rear doors of the trailer you gain full, easy access to all of
the grooming equipment and the water tanks.
The equipment list includes a Taxi Vac clipper vacuum system, Hi V Gold Dryer
with Turbo Booster, hot water heater, water pump, drain pump, 65 gallon fresh
water tank and a 65 gallon dirty water drain tank. A shampoo dispensing system
is included. A reversible 3 speed power roof vent is located above the tub area
and the grooming area has it's own roof top A/C unit that has a heat strip
included.
A Bathing Beauty power bathing system is an option for
a reduced cost of $499.

(Optional items shown in picture)
Our RSX Gooseneck Custom Trailer, starts at $42,000. The RSX Gooseneck has several options available, call us toll free today at (866) 281-9593 to discuss. All warranties will be included which includes just
about everything having a one year warranty. We will need about two weeks to
process your order and complete this conversion.
This is a toy hauler
trailer, not a cargo trailer, which from a quality perspective means; Frame- 5200 lbs. lube Rubber Torsion Axles, 12" Electric Brakes on Axles, Protection Under Carriage. Exterior- Premium Radio Tires, White Mod Wheels, 7 Way Round Connector, Flat Top / one Piece Roof Design, Smooth Aluminum Exterior with out rivets, Wrapped Rear Structure with Aluminum Trim.
The choice is yours. If this grooming unit fits your style
and your budget, give us a call as soon as possible, so we can start the conversion today!
Curtis Hanvey
Engineer/Founder
Hanvey Specialty Engineering |